Menu
Your Cart

Nanopositioner Controllers

Nanopositioner Controllers
Contact Us
Nanopositioner Controllers
  • Stock: Contact us for details
  • Click here to: Contact us
  • Model: nPoint Nanopositioner Controllers
£0.00

DSP-based servo controllers for nanopositioning piezo stages   

nPoint LC.400 Series Controllers   

The LC.400 series controller is the latest DSP based digital control system from nPoint. It combines ultra low-noise driver electronics and motion sensing modules with DSP-based servo control to provide superior closed-loop operation.

Positioning is achieved via commands sent over to a choice of standard and optional interfaces (see below), with feedback on stage position from either capacitive and strain gauge sensors - the LC.400 series controllers are compatible with both technologies.

Positioning linearity is better than 99.97% over the entire range of travel thanks to nPoint’s linearisation technique.

Stage calibration data and other parameters, such as control configurations, are stored onboard ready for use.

High-speed/ high-load configurations are catered for by high power amplifiers to provide the necessary current.

All in all, nPoint's LC.400 series prove to be one of the most flexible nanopositioning controllers on the market.

Specifications

Resolution20-bit
Processor32-bit floating point DSP
Sampling rate24 µsec servo-loop
Standard interfacesUSB
Analogue input (0 ± 10 V)
Analogue monitor output (0 ± 10 V)
Interface optionsAFM Inteface
9-pin I/O (with optional RS-232 functionality)
Digital Encoder Interface
Ethernet Interface
High Speed Parallel Interface
PFM (Pulse Frequency Modulation) Inteface
SoftwareEPICS Drivers
Internal wave form generator
LabVIEW and DLL drivers
Nikon Elements Compatible
nPoint control panel
ScanImage Compatible
uManager Drivers
HV driver voltage-30 to +150 V piezo drive
Command input voltageBNC 0 ± 10 V analogue position command signal (0 to 10 V optional)
Sensor monitor outputBNC 0 ± 10 V analogue sensor signal (0 to 10 V optional)
Sensor typeCapacitive or Strain Gauge - others optional
Max output current (mA)
  LC.400 (1-channel)
  LC.402 (2-channel)
  LC.403 (3-channel)

100 (150 optional)
100 (Up to 350 optional)
100 (Up to 350 optional)
Dimensions (mm)
  LC.400
  LC.402
  LC.403

106 x 67 x 172
185 x 67 x 240
260 x 88 x 264
Cables to stage2 m standard (custom lengths available)
Operating voltage100 – 240 VAC, 50 – 60 Hz
Operating systemMicrosoft Windows XP/Vista/7/8/10, Linux, Mac OS
CertificationCE, UL, CAN/CSA

nPoint website

There are no downloads for this product.